Flash monotron 200 user manual
Then turn the ADJ knob to increase or to decrease the minutes. To set the minutes, press the clock button again. Then turn the ADJ knob to increase or to decrease the hour. The clock symbol will appear on the audio display and the hour number will flash. Check page 3-39 Setting the Time To set the hour, press the clock button.
#Flash monotron 200 user manual manual#
I've the downloaded user manual to your set, and I'll send a copy of it to you by return mail. If you haven't the user manaul to your set with you now, send your email address to me by Fixya comment bos. When the time has been set, TIMER/CLOCK can be used to operate the daily timer recording timer. If the clock is not set 'AM 12:00' will flash instead of the clock indication. The clock stops flashing, and the clock timer starts from '0' seconds. Press 'Set' button.' CLOCK OK' appears on the display. Press (>P.UP) on the multicontrol to set Minutes. Press (>P.UP) on the multicontrol to set Hours. All settings will be cleared, return to clock mode, 12:00 MO, AM, AUTO OFF will be shown on LCD I hope this is helpful. RESET At any mode, press RESET for 5 seconds. NOTE: For normal timer function, the selection must be either 'AUTO ON' or 'AUTO OFF'.The wall socket is turned off) **AUTO OFF - Indicates that the timer is in the OFF mode until the next programmed step that turns it ON. **OFF - Indicates that the timer is always off (i.e.
**AUTO ON - At this selection, the timer will come on regardless of the programmed setting, but it will follow the next programmed command. **ON - Indicates that the timer is in the ON mode, and will always be on regardless of the programmed setting. 4 settings that serve as manual override.MANUAL OVERRIDE AND ALWAYS ON/OFF When in clock mode the +/MANUAL sign cycles through 3*Turn off DLST, +1H will disappear and LCD shows the real time.2*Turn on DLST, the below of LCD shows +1H.1*In clock mode, press RECALL to turn on or off the Daylight Saving Time.7*Press +/MANUAL to have LCD showing either 'AUTO ON' or 'AUTO OFF' for the timer to execute the programmed settings.6*When done setting programs press the MENU button to return to clock mode.5*Repeat steps 2-4 to complete PROG 1 setting.Press +/MANUAL to get to PROG 1 'OFF' blinking, press OK. Cycle through minutes +/MANUAL or - to desired minute, press OK. Cycle with +/MANUAL or - to desired hour, press OK. 1*Press MENU button, PROG 1 'ON' will flash, press OK.To clear a program setting hit the RECALL button when you have the program selected. To cycle through the individual programs use the +/MANUAL or - after pressing MENU in step one until the desired PROG '#' is flashing.
#Flash monotron 200 user manual download#
Gecko Iphone Toolkit Rev 2 Download more. We will use PROG 1 for this example, however these steps can be repeated for any of the 2 programs. PROGRAM SETTING NOTE: This timer can be set up for up to 2 different programs.4*Press MENU to exit the time setting mode.Press +/MANUAL or - to select the minute. Request any owner's manual, instructions book, user's guide, service manual, schematics, parts list. 2*Press +/MANUAL or - to select the hour.1*Press and hold the OK button for 4 seconds.BRINKS DIGITAL TIMER 44-1011 INSTRUCTIONS.I finally found the instructions for the Brinks timer 44-1011 and they work.